The OpenZwave beta integration is moving forward! Support for climate, fansĪnd locks is added this release! If you are using the OpenZWave add-on with.Allowing the overall startup process toĬontinue, resulting in a faster startup. No longer wait for the platforms to finish setting up. Often, an integration has a basic setup and will then load the various platformsĪs of this release, Home Assistant will set up the integration but will If an integration takes more time to set up, it will be shown in the logs everyĦ0 seconds, indicating that the integration is still being setup.Īnother speed improvement is found in the way we load up integrations themselves. Some more tuning to the startup process can be found in things like the logs. Theĭefault theme is used during the startup phase. Theme, it will be applied after Home Assistant has completely started. It will show warnings for entities that are not available yet and will updateĪnother additional note: If you use an automation to set your default frontend One additional note: If you run generated Lovelace, it will still wait for The Supervisor handles the surprisingly fast available frontend as well. The base for this change came from his creative brains, so thanksįor that! did all the frontend work and made sure Finally, it easier to check out your logs when something Also, as soonĪs it is available, you can change or remove the configuration of a non-working This is actually good! As this means, an integration that got into trouble,Ĭan no longer prevent the frontend from becoming available. As a result, not all devices and entities are available immediately. However, with this change, Home Assistant no longer waits for all integrations Instead of waiting a couple of minutes until the Home Assistant frontendīecomes responsive, it is available really fast now! ![]() This means you can interact with Home Assistant In this version, we start the Home Assistant frontend and API server before all It is definitely worth looking at the “All Changes” section this release,Īs many many small changes and fixes have been made. Most notably, is the change on how Home Assistant loads up the frontend. This release is focussed around more stability, fixing, tweaking and tuning. It contains 400+ changes made by a group of 100 contributors! So I’m not sad! ![]() Time to play! This time, however, not so much to play with. Personally, I’m always looking forward to the new features a new release brings. It was pretty exciting! It will be hard to top that. Was just jam-packed with new features, tons of upgrades and a lot of stuffĬhanging. So, let’s face it: the previous release ( 0.110)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |